Thiết bị vật tư truyền hình · Seehai
High-Pass Filter
SHPF-6585-FAll-in-one brass structure with nickel-plated surfa Small size fit for indoor use. Can be installed separately, or as…

The inside connector is with silicone rubber waterproof ring, to resist moisture and dust.
Applicable to the cable quad-shield of ES59, F59 HEC-2
Các thông số bên dưới trích từ catalog sản phẩm.
Specification:
| No. | Item | Connector for RG6 cable | |
| 1 | Connector Type | F-type (British) | |
| 2 | Operating Frequency Range | 5MHz~1000MHz | |
| 3 | Impedance | 75Ω | |
| 4 | Insertion Loss | 5MHz~300MHz | ≤0.05dB |
| 5 | 300MHz~1000MHz | ≤0.1dB | |
| 6 | Return Loss | 5MHz~300MHz | ≥30dB |
| 7 | 300MHz~1000MHz | ≥30dB | |
| 8 | Screening Attenuation | ≥100dB | |
| 9 | Contact Resistance | Inner Conductor | ≤10mΩ |
| Outer conductor | ≤5mΩ | ||
| 10 | Insulation Resistance(DC 500V) | ≥1000MΩ | |
| 11 | Withstanding Voltage | AC 1.5KV, 1min, no breakdown | |
| 12 | Water and fog resistant(SCTE standard: ANSI/SCTE 60 2004 red dye,120 hours,high-low temperature cycle,test condition please check Tips 1) | No leakage | |
| 13 | Water immersion test (24h) | Insulation resistance≥200MΩ, The resistance voltage meets the requirements of item 11 | |
| 14 | Resistance to damp heat test | Withstand voltage | ≥800V |
| (40℃±2℃,93%±3%,24h×21) | |||
| Insulation resistance | ≥250MΩ | ||
| (40℃±2℃,93%±3%,24h×21) | |||
| 15 | High temperature insulation resistance | ≥500MΩ | |
| (85℃±5℃,16h) | |||
| 16 | Low temperature insulation resistance | ≥1000MΩ | |
| (-40℃±5℃,2h) | |||
| 17 | Working torque strength of connector | ≥3.39 Newton-meters | |
| 18 | The length of connector (after finished the compression) | ≤25mm | |
| 19 | Connect strength of connector and cable (Double shield cable) | ≥20kgs | |
| 20 | Universality of connector | The same model connector can be used in F59 HEC-2 cable with double, triple and quad-shield. | |
| 21 | Operating temperature | -40℃ - +60℃ | |
| Tips 1: SCTE standard: ANSI/SCTE 60 2004 Resistance to damp heat test method. Environmental temperature: upper limit 60±1℃, lower limit 1.7±1℃. Put the connector on this environment to test 120 hours, and looping 10 times on the temperature limits. Each cycle must be maintained at a maximum temperature of 300 + / -20 minutes. |
Gửi yêu cầu để được hỗ trợ chọn thiết bị và phương án kết nối.