High-Pass Filter
SHPF-6585-FAll-in-one brass structure with nickel-plated surfa Small size fit for indoor use. Can be installed separately, or as…

Block Diagram:

870MHz 2 Way Amplifier Big Housing and Three Amplification Modules
Các thông số bên dưới trích từ catalog sản phẩm.
Specification:
| ITEMS | FORWARD PATH | RETURN PATH |
| Frequency Range | 82 ~ 870 MHz, or higher | 5 ~ 65 MHz |
| Operating Gain (Includes DPXs, EQs, AGC, …, and Direct Output Module) | ≥ 38 dB, full range | ≥ 20 dB, full range |
| Response Flatness | ≤ ± 0.75 dB | |
| Gain Control Range | 0 ~ 20 dB Adj. / plug-in PAD | 0 ~ 20 dB Adj. / plug-in PAD |
| Slope Control Range (Fixed value, Plug-in modules) | 3 ~ 12dB | 3 ~ 9dB |
| Noise Figure | ≤ 9 dB | ≤ 9 dB |
| Return Loss (75-ohm Reference) | ≥ 12 dB, full range | |
| Recommended Output Levels (Direct Output) | ≥ 38 / 50 dBmV (82 / 870 MHz) | ≥ 42 / 42 dBmV (5 / 65 MHz) |
| Rated Signal Level Distortion (*) | ||
| Cross Modulation (XMOD) | ≤ - 60 dB | ≤ - 60 dB |
| Composite Second Order (CSO) | ≤ - 63 dB | ≤ - 63 dB |
| Composite Triple Beat (CTB) | ≤ - 63 dB | ≤ - 63 dB |
| Input / Output Impedances | 75 ohms, 5/8-24 Female | |
| Hum Modulation | ≥ 65 dB @ 10A passing current | |
| Power Requirements | 40 ~ 90 VAC / 50 ~ 60 Hz | |
| Internal Circuit Voltage | 24 ± 0.3 VDC (high efficient switchmode power supply), withstand ≥1.5A Load. Overload, overvoltage, short circuit protection. | |
| Housing Design | Die-cast aluminium housing design with paint/coating for: - Good heat spread (Operating Temp.: 0 ~ +60oC, or wider). - RF shielding ≥ 110 dB. - IP67 degree of dust and water protection. - For strand and pedestal mounting. |
NOTE:
-Measured with 132 NTSC (or 96 PAL) channels of Forward Path, at least 4 T-channels of Return Path, at Recommended Output Levels.
- Support Adj. Attenuator / plug-in Attenuator (PAD), plug-in DPX, and plug-in EQ between hybrid modules.
- Support Forward IN and OUT Test Ports (-20 dB), Return IN and OUT Test ports (-20 dB).
- Support one or two outputs by plug-in jumper or splitter.
- Return Attenuator and EQ are designed / located at OUTPUT of Return Amp. Module.
- Lightning Arrestors at all IN/OUT Ports.
Gửi yêu cầu để được hỗ trợ chọn thiết bị và phương án kết nối.