High-Pass Filter
SHPF-6585-FAll-in-one brass structure with nickel-plated surfa Small size fit for indoor use. Can be installed separately, or as…

This product is FTTH (Fiber to the Home) optical receiver, with low power optical receiving and optical control AGC technique, which can satisfy the demand of FTTH, and also can match with ONU or EOC for realizing the integration of three networks. With WDM, 1550nm CATV to be photoelectric converted for RF output, 1490/1310 nm PON signals directly pass, can transfer CATV+EPON by only one pc optical fiber.
The product is with compact structure, it is easy to install, and this is an ideal product for FTTH CATV network
Các thông số bên dưới trích từ catalog sản phẩm.
Specification
| Item | Unit | Specification | |
| Receiver Type | Photodiode with brand name from G7/EU countries | ||
| Amplifier Type | MMIC with brand name from G7/EU countries | ||
| CATV Wavelength | nm | 1550±10 | |
| PON Wavelength | nm | 1310/1490 | |
| Optical Input Power | dBm | -18~+2 | |
| Optical AGC Range | dBm | -11~+2 | |
| CATV Optical input port | SC/APC | ||
| PON Optical reflect port | SC/APC | ||
| RF connector | F-Female | ||
| Frequency | MHz | 47~1000 | |
| Flatness | dB | ≤±1.25 | |
| RF Output Level (in AGC range) | dBμV | ≥80 | |
| Output RF resistance | Ω | 75 | |
| Output Return Loss | dB | ≤-12 | |
| C/N | dB | ≥43 | -9dBm Optical input power, 60 PAL channels |
| C/CSO | dB | ≥55 | |
| C/CTB | dB | ≥55 | |
| MER | dB | ≥31 | -15dBm optical input power |
| Power Supply Voltage | AC\V | 100~240 (Input of adaptor) | |
| Input Voltage | DC\V | +5V/12V(Input of product, output of adaptor) | |
| Power Dissipation | W | ≤2 | |
| Operating Temperature | ℃ | -10~+50 | |
| Dimension | mm | 95×60×23 (L×W×H) |
Block Diagram

Interface introduction

1. LED indicator for power supply. If power supply works normally, the LED indicator will be green; if fails or power off, the indicator will be off.
2. LED indicator for optical receiving power. When optical receiving power is higher than -12dBm, the LED indicator will be green. When optical receiving power is lower than -12dBm, the LED indicator will be red.
3. CATV optical input port: SC/APC.
4. RF output port. Use coaxial cable to connect with the RF input port of TV or STB.
5. Power input port. Connect with the attached power adaptor.
6. PON optical output port: SC/APC.
Gửi yêu cầu để được hỗ trợ chọn thiết bị và phương án kết nối.